Trainer rides and tempo runs

I volunteered at the Mighty Magnolia on Saturday. It was tough watching the athletes. I wanted to be out there. The weather was beautiful. I think I could have competed well.

When I got home from the race I was a little bummed out. I decided to jump on the trainer and smash out a workout. I loaded up a difficult session. It would be 3 x 6 minutes at a challenging wattage. The recovery would be relatively short at 3 minutes. If you remember I was first successful with this workout at the beginning of the summer. I have since failed twice.

I killed the workout out. Yes it was tough but I was able to complete it. However, there were a couple of different variables. First, my heart rate monitor was not working. In addition, my Garmin malfunctioned. One of the buttons got stuck. I could not see my heart rate – not on my computer (hooked to the trainer) or on my Garmin. I was riding blind. I also decided to pedal at a lower cadence so that I could start to build some leg strength.

So I do not know how hard I was working but I was able to complete the session. Once again, I would not say that it was easy but it was achievable. I was satisfied with the effort.

On Sunday I had a solid run. I have been trying to add some speed into my workouts. I have a half marathon at the end of the month. I will be using this race to base my training for the next few months. I believe that my running is improved from this time last year and it should allow for me to build on this base.

Instead of running by pace I decided to mix it up and run by my LTHR. I had previously determined this level by my average heart rate at my last 5k (the pump and run). My LT zone was 175 – 185 beats per minute. I started out on my run at my easy pace – about 8 minutes per mile. I then picked up the pace and tried to keep my heart rate in the mid 170’s.

I ran the next 8 miles at this hard level. This level starts out comfortably hard and then slowly increases to hard. I tried to my pace and just concentrate on the heart rate and rate of perceived exertion. I continued along just running hard. My heart rate climbed a little bit as the run went on but I was successful. After the 8 miles at pace I slowed it down for the last mile. I completed the run on 1:10:24 for an average pace of 7:02. I have run 10 miles at 7 minutes per mile pace before – a couple of times. This can be hard but it is achievable – even in training. However, I was pleased with the 8 miles at speed. I completed the 8 miles with an average heart rate of 172 BPM in 53:46 (6:43 minute per mile). Now this was a training run and in a race situation I should be able to push a little bit harder and a little bit further. On the flip side, I only ran 8 miles – about 5.1 miles short of the goal. I have 20 more days to put it all together.

All in all, I am faster than a year ago but I still have my work cut out for me.

Anaerobic Threshold Test -

I decided to do some benchmark cycle performance testing on my indoor trainer. My trainer will display (on the computer) your heart rate, speed, cadence, and power. Using these parameters and the instruction from Joe Friel’s The Cyclist’s Training Bible I set out to conduct the test. I warmed up for 2 miles (about 6 minutes) on the trainer. I loaded a 10 mile course with 0 slope. The test instructs you to start at 100 watts and increase your power output by 20 watts every minute. At each minute you record your power, speed, heart rate and perceived exertion (scale from 6 – 20 - very very easy to very very hard). I wish that the results were a little better but it gives me a baseline to improve upon.



I will retest this approximately monthly to determine if my cycle training is improving.